![background image](http://html1.mh-extra.com/html/parkside/pmnf-1350-c3/pmnf-1350-c3_original-instructions-manual_4156947013.webp)
1 3
NI
IE
GB
rectly. The take-up flange‘s (19)
contouring must face towards
the motor. If you turn the take-up
flange (19), the take-up spindle
(16) must turn with it.
9. Position the desired cutting disk
(8) on the take-up flange (19).
The label on the disc should al-
ways face the device.
10. Set the desired cutting width by
selecting the spacer disks (20).
Push the spacer disks onto the
take-up spindle (16). This is fol-
lowed by the flange (21). This is
followed by the second cutting
disk (8). All separator disks (20)
not used for setting the cutting
width must be pushed onto the
take-up spindle (16) after the
second cutting disk.
11. Reposition the threaded clam-
ping flange (17) on the take-up
spindle (16).
12. Press the spindle retaining tab
(7), and turn the take-up spindle
(16) until the spindle retainer
fixes the take-up spindle (16).
Retighten the threaded clamping
flange (17) using the chuck key
(13). You can now release the
spindle retaining tab (7).
Setting the groove depth
1. Release the retaining screw (18).
2. Set the depth-stop to the required
depth. Adjust the protective
guard (5) to do this.
3. Reattach the protective guard (5)
with the retaining screw (18).
Vacuuming
During operation, the wall chaser gene-
rates a large quantity of dust. You should
therefore wear a dust mask, and always
connect an industrial vacuum cleaner.
If the vacuum system malfunctions, pause
operation and clear the malfunction!
Attaching the vacuum cleaner
Unscrew the suction connector (10) cap.
Insert the industrial vacuum cleaner’s hose
through the cap and screw the cap tight.
If your vacuum cleaner’s hose is the wrong
diameter for a direct connection, you can
insert the vacuum adapter (11) in between
with a single turn.
Always attach a vacuum cleaner. Damage
to the motor caused by failure to attach
a vacuum cleaner is not covered by the
warranty.
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and acces-
sories recommended by the ma-
nufacturer. Using other attachment
tools and other accessories can
represent a risk of injury for you.
- Only use grinding tools which
bear information about the
manufacturer, type of binding,
dimension and permitted number
of revolutions.
- Only use grinding discs where
the printed rotational speed is at
Summary of Contents for PMNF 1350 C3
