Parkside PMGS 12 D3, Translation Of The Original Instructions

Page: 11 / 32

PMGS 12 D3 ■ 8 │
GB
│
IE
│
NI
Safety instructions for LED lights
WARNING! RISK OF INJURY TO THE
EYES!
■ Never aim the light directly at people or ani-
mals and never look directly into the light
beam of the LED light.
Safety instructions for batteries
CAUTION!
■ Do not leave used batteries in the device as
even leak-protected batteries corrode and
chemicals can be released which could dam-
age your health or destroy the appliance. Do
not leave batteries lying around unattended.
They could be swallowed by children or
pets. In case of swallowing, consult a doctor
immediately.
■ If you do not plan to use the appliance for
an extended period, remove the batteries to
prevent leakages.
■ Leaking or damaged batteries can cause skin
irritations if touched. If this occurs, wear suit-
able gloves.
■ Ensure that batteries cannot be short-circuited.
Do not throw batteries into a fire.
■ Do not attempt to recharge non-rechargeable
batteries. There is a risk of explosion!
Appliance-specific safety instructions
for transformers
Only for indoor use!
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity.
■ Wear safety goggles and a protective dust
mask!
■ Safety transformer fail-safe
■ Thermal link
Operation
■ Never use the appliance for other purposes
and only original parts/accessories.
Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
Changing the batteries
♦ Make sure that the LED light is turned off. Remove
the three screws from the rear of the grip ring
with LED .
♦ Replace the used batteries in the appliance
with new batteries of the same type (button
cell LR41). Note polarity when installing new
batteries.
♦ Close the battery compartment again by replacing
the three screws.
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock and hold it down.
♦ Turn the tensioning nut until the lock clicks
into place.
♦ Undo the tensioning nut from the thread
using the combination key .
♦ Remove any attached tool.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate
collet chuck for the tool shaft.
♦ Press the spindle lock and hold it down.
♦ Push the collet chuck into the thread insert
and screw the tensioning nut tight with the
combination key .