Parkside pmfw 310 b1, Operation And Safety Notes Translation Of The Original Instructions

Page: 11 / 65

11 GB/IE
Assembly / Bringing into use / Maintenance and cleaning Assembly
HCS
B
Segment saw blade Z85 B3
8
Material:
Wood
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
HCS
Scraping knife Z52 A2
9
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)
Q
Changing the attached tool
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
“Connecting a vacuum dust extraction device”).
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Remove any tool already inserted. To do this,
release the clamping screw
10
using the Hex
key
11
and take off the tool.
Place the tool (e.g. plunge saw blade
6
) on
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
Fasten the tool in place with the clamping
screw
10
and clamping plate
4
. Tighten the
clamping screw
10
using the Hex key
11
.
Check that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
Q
Place a sanding sheet
on the backing plate
Offer up the sanding sheet
12
to fit flushly on
one side of the backing plate
7
, then apply
the sanding sheet to the backing plate.
Q
Bringing into use
Q
Switching on / off
Slide the ON / OFF switch
1
forwards to
switch on the device.
Slide the ON / OFF switch
1
backwards to
switch off the device.
Q
Selecting the oscillation speed
Preselect the required oscillation speed using
the oscillation speed setting wheel
2
.
NoTE: The required oscillation speed depends on
the material and the working conditions and can
be determined by means of a practical test.
Q
Maintenance and cleaning
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.