Parkside PISG 120 B3, Operation And Safety Notes

Page: 19 / 117

19 GB
z
Maintenance and
cleaning
Note:
The welding device must be
regularly serviced and overhauled for
proper function and for compliance with
the safety requirements. Improper and
wrong operation may cause failures and
damage to the device.
„
Before performing cleaning work on
the welding tool, disconnect the
power cable
10
from the power
outlet to ensure the tool is safely
isolated from the power supply.
„
Clean the exterior of the welding
device and its accessories regularly.
Use compressed air, cotton waste or
a brush to remove dirt and dust.
Note:
The following kinds of mainte-
nance work must be performed only by
suitably-qual ified personnel.
„
The current regulator, earthing
device, internal cables, the coupling
device of the welding torch and
adjusting screws must be serviced
regularly. Re-tighten loose screws
and replace rusty screws (replace-
ment M4 x 10 screws are available
in any commercial hardware store).
„
Check the insulation resistance levels
of the welding device regularly.
To do this use an appropriate
measuring device.
„
In case of a defect or a necessary
replacement of equipment parts,
please contact the appropriate
qualified personnel.
z
Information about
recycling and disposal
Don’t throw away –
recycle
Please return this device, accesso-
ries and packaging to your local
recycling depot.
According to European Directive
2012/19/EU, used electrical devices
must be collected separately for envi-
ronmentally compatible recycling or
recovery. Please return this device to an
approved waste management company
or use your municipal waste collection
service. Please ensure you comply with
local regulations. If you have any ques-
tions, please contact your local authority
or waste management company.
z
EU Declaration of
Conformity
We,
C.M.C. GmbH
Responsible for documentation:
Dr Christian Weyler
Katharina-Loth-Str. 15
66386 St. Ingbert
Germany
hereby take sole responsibility for
declaring that the product
Inverter welder
Art. no.:
2338
Year of manufacture:
2021/18
IAN:
337360_2007
Model:
PISG 120 B3
meets the basic safety requirements as
specified in the European Directives
EC low-voltage directive:
2014 / 35 / EU
EC Guideline on Electromagnetic
Compatibility:
2014 / 30 / EU
RoHS directive:
2011 / 65 / EU+2015/863/EU
Maintenance and cleaning / Information about recycling ... / EU Declaration ...