Parkside PHET 15 A1, Instruction M

Page: 32 / 36

29 PHET 15 A1
GB
5. Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the
power tool is maintained.
Appliance-specific safety instructions
for tackers
■
Always assume that the power tool contains
staples.
Careless handling of the tacker can
lead to unexpected ejection of staples which
could cause injuries.
■
Never aim the power tool at yourself or
other people in the vicinity.
Unintended
triggering will cause a staple to be shot out,
which can lead to injuries.
■
Do not activate the power tool until it is
pressed firmly against the workpiece.
If the
power tool is not in contact with the workpiece,
the staple can rebound off the fastening point.
■
Disconnect the power tool from the mains
or battery if a staple becomes jammed in
the power tool.
If the tacker is connected, it
could be unintentionally activated while removing
a jammed staple.
■ Be careful when removing a jammed
staple.
The system may be under tension and
the staple could be forcefully ejected while you
attempt to unblock the jam.
■ Never use this tacker for fastening electrical
cables.
It is not suitable for the installation
of electrical lines, can damage the insulation
of electrical cables and thus cause electrical
shocks and increase the risk of fire.
Supplementary notes
■
PROTECT YOUR EYES!
Wear eye protection
or goggles. This also applies to people who are
carrying out support and holding work during
operation.
■ Secure the workpiece. A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■ Always guide the power cord away to the rear
of the appliance.
Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment
that are specified in the
operating instructions and are compatible
with the appliance.
Operation
Filling the magazine
WARNING! RISK OF INJURY!
■ Switch the appliance off and remove the
power plug before commencing any work to
the appliance.
♦ Turn the appliance around.
♦ Press the release together (see Fig. A).
♦ Pull the magazine backwards (see Fig. A).
♦ Fill the magazine shaft with staples or nails
(see Fig. B).
NOTE
► Nails can only be inserted into the magazine
shaft on the left – as shown.
♦ After filling, push the release as far as the
stop in the magazine until it clicks into place.
NOTE
► By means of the fill level indicators ,
you can tell whether the magazine contains
staples or nails.