Parkside PHET 15 A1, Operation And Safety Notes

Page: 33 / 35

33 GB
Safety … / Start-up / Operation / Maintenance and Cleaning / Warranty
ble installation and may damage the insulation
of electric cables thereby causing electric shock
or fire hazards.
Supplementary instructions
PROTECT YOUR EYES! Wear protective
glasses. This also applies to people who are
assisting by supporting or holding in place.
Secure the work-piece firmly. Use clamps or a
vice to firmly hold the work-piece. This results in
a safer grip than with your hand.
Always ensure that the cable is behind the device.
Original accessories / tools
Use only the accessories and attachments de-
tailed in the operating instructions, or those which
are compatible with the device.
Start-up
Inserting the magazine
Turn the device.
Press the unlocking device
3 a
together (see fig. A).
Pull the magazine
3
back (see fig. A).
Fill the magazine well
4
with staples or nails
(see fig. B).
NOTE: Nails can only be inserted left into the
magazine well
4
- as shown.
Once full push the unlocking device
3 a
until it
hits the magazine
3
and until it engages.
NOTE: The fill level indicators
5
,
6
show if
there are staples or nails left in the magazine.
Operation
Switching on
Press the device on the place on the material
where you want to staple / nail.
Undo the start lockout
1
.
Press the trigger
2
.
Troubleshooting
DANGER OF INJURY!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
Cause:
A staple or nail is blocking the device.
Solution:
Open the unlocking device
3 a
. Loosen the
pretension.
Remove the staple or nail.
Maintenance and Cleaning
DANGER OF INJURY!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
Always keep the device clean, dry and free of
oil or grease.
Use a dry cloth to clean the housing.
If the connection cable needs to
be replaced, this repair must be performed by
the manufacturer or a representative to prevent
safety hazards.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
General power tool safety warnings / Safety instructions for tackers