Parkside PDWE 8 A1, Operation And Safety Notes Translation Of The Original Instructions

Page: 12 / 38

GB/IE/NI 12
of oil.
z „
The integrated sight window permits continuous
overview of the filtered compressed air.
z „
To top up oil, turn the screw (B) down with
a suitable socket wrench. Fill the tank with a
matching hopper and tighten the screw again
with the wrench.
Troubleshooting
Faults Causes Solution
The lubrication
is not sufficient The oil pas-
sage screw it
tightened too
far in direction
("–"). Increase
lubrication
(see above).
The com-
pressed air
volume is too
low, i.e. below
the minimum
fill level. Pour more oil
into the oil
tank. Observe
the maximum
fill level.
The operating
pressure of the
compressed
air is too low. The pressure
controller
is tightened
too far
(see above). Increase the
pressure
(see above).
Cleaning and maintenance
Note:
The pneumatic maintenance unit must be
regularly serviced and overhauled for
proper function and for compliance with the safety
requirements. Improper and wrong operation may
cause failures and damage to the device.
z „
Never use any sharp and/or scraping cleaning
agents or solvents. They may damage the plas-
tic parts of the pneumatic maintenance unit.
z „
Make sure that no water can enter inside the
oiler.
z „
Ensure that the housing and the inside of the
pneumatic maintenance unit remains dust- and
dirt-free. For this, regularly rub the pneumatic
maintenance unit with a clean cloth.
z „
Clean the pneumatic maintenance unit and the
connections with a moist cloth at regular intervals.
z „
Drain the pneumatic maintenance unit's tank
at regular intervals. For this, press in the metal
pin at the bottom and let the condensate drain.
Note that the pneumatic maintenance unit must
be depressurised for safety.
Warranty and service
information
Warranty from Creative Marketing
Consulting GmbH
Dear Customer,
The warranty for this device is 3 years from the
date of purchase. In the event of product defects,
you have legal rights against the retailer of this
product. Your statutory rights are not affected in
any way by our warranty conditions, which are
described below.
z z
Warranty conditions
The warranty period begins on the date of pur-
chase. Please retain the original sales receipt. This
document is required as your proof of purchase.
Should this product show any defect in materials
or manufacture within 3 years from the date of
purchase, we will repair or replace it – at our
discretion – free of charge. To claim against this
warranty, you must present the defective device
and your purchase receipt within the 3-year period,
and include a brief written description of the nature
of the defect and the date it occurred. If the defect
is covered by our warranty, we will repair and
return your product or send you a replacement.
The original warranty period is not extended when
a device is repair or replaced.
z z
Extent of warranty
The device has been manufactured according to
strict quality guidelines and meticulously examined
... / Cleaning and maintenance / Warranty and service information