GB/IE/NI
15
Warnings specific to the pneumatic angle grinder / Operation
Otherwise, accessories turning
faster than permitted may be
damaged irreparably.
z
Make sure that the parting disc
size is appropriate for the pneu-
matic angle grinder and that the
parting disc fits on the spindle.
z
Parting discs must be stored and
handled with care and in accord-
ance with the manufacturer’s
instructions.
z
Inspect the parting disc before
use, and discard all that have
spalled, fractured, or sustained
any other damage.
z
Before use, make sure that the
parting disc has been fitted cor-
rectly and tightened securely, and
let the device run idle for thirty
seconds in a safe place. Stop the
machine immediately there are
considerable vibrations or defects.
If this is the case, examine the
devices and identify the cause.
z
Do not use separate adapters or
adapter bushes: use instead
parting discs with a larger hole
diameter.
z
Always use the recommended
guard supplied with the pneumatic
angle grinder. The opening in the
guard must face away from the
operator.
z
Do not use angle grinders for
face cutting.
z
The parting disc continues
rotating even after the device has
been switched OFF. After switch-
ing OFF, the device may not be
put down until the parting disc
has come to a complete stop. This
precautionary measure serves to
prevent not only serious accidents,
but also dust and chips from being
sucked into the devices.
z
Operation
z
z
Before starting up
Fit the parting disc
Disconnect the compressed air supply from the
compressed air connection.
Use the assembly key
7
to lock the spindle in
place, at the same time loosening the hex screw
and flange with the Allen key
8
.
Fit the new parting disc
6
and flange on the spin-
dle. Use the Allen key
8
to tighten firmly the Allen
screws. Check that the parting disc has been fitted
correctly and can rotate without hindrance!
Protective cowl
Flange
75 mm parting disc
Hex screw
Spindle
Trigger arm
Switch ON guard
Compressed air connection
Compressed air supply and connection. Use
filtered, lubricated, and regulated compressed air
only. The following figure illustrates the correct way
292193 Druckluft-Trennschleifer_content_LB6.indb 15
01.12.17 09:56
Summary of Contents for PDTS 6.3 A1
Page 3: ...A B C 4 3 2 7 8 1 5 6 9 292193 Druckluft Trennschleifer_cover_LB6 indd 5 01 12 17 10 06...
Page 4: ...292193 Druckluft Trennschleifer_cover_LB6 indd 6 01 12 17 10 06...
Page 34: ...DK 34 292193 Druckluft Trennschleifer_content_LB6 indb 34 01 12 17 09 56...
Page 84: ...FR 84 292193 Druckluft Trennschleifer_content_LB6 indb 84 01 12 17 09 56...