Parkside PDSS 16 A1, Translation Of The Original Instructions, Page: 21 / 192

PDSS 16 A1
■ 18 │
GB│CY
Operation
Changing/inserting the tool/collet chuck
CAUTION!
► The shaft diameter of the tool must exactly match the clamp
bore of the collet chuck / (Ø 6 .35 mm/3 .2mm)!
♦ Hold the spindle using the assembly tool .
♦ Unscrew the collet chuck nut from the thread using the
assembly tool .
♦ Insert the tool into the collet chuck / .
♦ Hold the spindle using the assembly tool .
♦ Tighten the collet chuck nut using the assembly tool .
■ Ensure the accessory tool is firmly attached .
CAUTION!
► If no tool is inserted into the collet chuck / , do not tighten
the collet chuck nut
with the assembly tool , screw it on
by hand only!
Switching on and off
Switching on:
♦ First, press the trigger lock forwards and then the trigger
down to switch the tool on .
Switching off:
♦ Release the trigger .
♦ When you have finished working, disconnect the tool from the
compressed air source .