PDMFW 15 A1
GB
│
IE
│
25
■
NOTE
►
Before fitting a new sanding sheet , remove
any dust and dirt from the sanding plate .
►
Ensure that the dust extraction holes of the
sanding plate and sanding sheet are flush.
Removal:
♦
Simply pull the sanding sheet off the sander
plate .
Switching on and off
Switching on:
♦
First, press the trigger lock forwards and
then the trigger to switch the tool on.
Switching off:
♦
Release the trigger .
♦
When you have finished working, disconnect
the tool from the compressed air source.
Maintenance and cleaning
WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
CAUTION!
►
Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes). Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis. If dust is
produced or swirled up during maintenance,
it can be inhaled.
NOTE
►
To ensure correct functioning and a long
service life for the tool, pay attention to the
following points:
■
Sufficient and continuous oil lubrication is highly
important for optimum functioning.
■
If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired.
■
Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk. In doubt, contact the
Service Centre.
■
Clean the tool with a soft, dry cloth only.
■
Never use sharp or abrasive cleaning agents
under any circumstances.
Troubleshooting
Fault
Possible
cause
Remedy
Speed too
slow, air
escapes from
the outlet.
Motor parts
jamming due
to dirt.
Check the
pressure
supply filter
for contamina-
tion.
Pressure
supply too
low.
Check the
pressure
supply filter
for contamina-
tion.
Lubricate the
tool as de-
scribed in the
instructions.
If necessary,
repeat the
steps outlined
above.
Tool does
not move;
compressed
air escapes
completely
through the
outlet.
Motor is
jammed due
to material
build-up.
Lubricate the
tool as de-
scribed in the
instructions.
Summary of Contents for PDMFW 15 A1
Page 3: ...Z52 C3 Z85 D4 HCS HCS Z32 D4...
Page 17: ...PDMFW 15 A1 14 DE AT CH...
Page 31: ...PDMFW 15 A1 28 GB IE...
Page 73: ...PDMFW 15 A1 70 CZ...