Parkside PAT 12 B2, Operation Manual

Page: 23 / 85

21 GB
˜
Setting the impact force
NOTE
u
Select the lowest impact force that is
sufficient for fastening works to avoid over
driving or damaging the materials to be
fastened.
Increasing the impacting force:
Turn
the impact force control
[ 1]
in a clockwise
direction (towards the
+
marking).
Decreasing the impacting force: Turn
the impact force control
[ 1]
in a anti-clockwise
direction (towards the – marking).
If the impact force is set correctly, the crown
of the staple or head of the nail is flush with
the fastened material.
˜
Clearing jammed staples/nails
m WARNING!
If a staple or nail is jammed, do not
pull the trigger
[ 3]
!
Staples or nails may
otherwise be triggered accidentally by the
product after removing the staples or nails.
Remove the battery pack
[ 5]
from the
product before clearing the jammed
staples or nails.
Open the magazine
[ 8]
by pulling the push
rod
[ 9]
from the product.
Remove the jammed staples/nails from the
magazine
[ 8]
.
˜
Checking the battery level
(Fig. G)
Press down the safety contact
[ ]
onto a hard
surface. The remaining energy level is shown
on the LEDs of the battery level indicator
[ 2]
.
LEDs Battery level
Red below 30 %
Red and orange 30–70 %
Red, orange and green above 70 %
NOTE
u
When the battery level is below 30 %:
Charge the battery pack
[ 5]
.