Parkside PAH 1300 B2, Operation And Safety Notes

Page: 9 / 50

9 GB
Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power tool is
maintained.
Hammer safety warnings
a) Wear ear protectors. Exposure to noise
can cause hearing loss.
b) Use auxiliary handle(s), if supplied
with the tool.
Loss of control can cause
personal injury.
c) Hold power tool by insulated gripping
surfaces, when performing an oper-
ation where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a “live“ wire
may make exposed metal parts of the power
tool “live“ and could give the operator an
electric shock.
d) Wear a dust mask.
Installation
Additional handle
Undo the knurled nut
5
.
Swing the additional handle
4
around the
product axis or 180 ° forward or backward
into the desired position (see Fig.).
Retighten the knurled nut
5
.
Note:
only use the tool with the additional
handle
4
.
Fitting a tool
Pull the locking sleeve
8
back.
Insert the tool by twisting it into the tool holder
7
until it clicks into place.
Release the locking sleeve
8
to lock the
holder. Pull the tool to ensure that it is firmly
locked in place. The tool has a radial clear-
ance which is determined by the system.
Removing a tool
Pull the tool's locking sleeve
8
back and pull
the tool out from the tool holder
7
.
Adjusting the chisel position
Insert the flat chisel
10
into the tool holder
7
.
Bring the flat chisel
10
into the best possible
working position.
Push the chisel adjustment ring
6
forward.
Rotate the flat chisel
10
using the chisel ad-
justment ring
6
into the required position.
Then, release the chisel adjustment ring
6
and
rotate it until it clicks in.
Start-up
Switching on and off
When operating the device you can choose be-
tween intermittent or continuous operation mode.
Intermittent operation mode:
To switch on intermittent operation mode, hold
the ON / OFF switch
3
.
To switch off intermittent operation mode,
release the ON / OFF switch
3
.
Continuous operation mode:
To switch on continuous operation mode, press
the ON / OFF switch
3
and lock this while
pressed using the lock
2
.
To switch off continuous operation mode, press
the ON / OFF switch
3
and release it once
more.
You can use the chisel on concrete, brick, stone
and asphalt as well as to remove tiles and
flooring.