Parkside 327358 1904, Operation And Safety Notes

Page: 20 / 145

20 GB/CY
Troubleshooting
Air current cannot
be regulated?
„
Compressed air hose
damaged or faulty.
„
Valve/manometer fails.
„
New connection of the hose.
HF-arc is not
created?
„
The burner switch is faulty.
„
Soldering point on the burner
switch or plug loosened.
„
Valve/manometer fails.
„
Renew electrode.
Bad ignition?
„
Burner wear parts damaged
or worn.
„
Check HF spark gap.
„
Change wear parts.
„
Set spark gap.
Plasma burner 8
is not ready for
operation?
„
Current switch is switched off.
„
Air transmission is restricted.
„
Workpiece is not connected to
the ground terminal.
„
Switch the current switch
to “on”.
„
Another indication of this is
a green flame. Check the air
supply.
„
Check the connections.
Sparks fly
upwards, instead
of down through
the material?
„
Burner sleeve 8c does not
penetrate the material.
„
Burner sleeve 8c is too far
away from the material.
„
Apparently material was not
grounded properly.
„
Lifting speed is too quick.
„
Increase the current.
„
Reduce the distance between
the burner sleeve 8c and
material.
„
Check the connection for
correct grounding.
„
Reduce the speed.
Initial cut but not
completely drilled
through?
„
Potential connection problem.
„
Check all connections.
Slag formation on
interfaces?
„
Tool/material creates heat.
„
Cutting speed too low or
current too high.
„
Plasma burner component
parts are worn 8b , 8c , 8d , 8e .
„
Allow the material to cool
down and then continue
cutting.
„
Increase the speed and/or
reduce the current until the
slag has been reduced to a
minimum.
„
Check and replace worn
parts.
327358_Plasmaschneider_PPS_40_B2_content_LB7.indb 20 13.09.2019 08:42:44