Parkside 322485-1901, Translation Of The Original Instructions

Page: 9 / 40

PMFS 200 C3 ■ 6 │
GB
│
IE
│
NI
│
CY
Before use
Fitting/changing the sander plate
WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance .
♦ Use the appropriate sander plate for
the corresponding application .
♦ Remove the four screws using the supplied
hex key
4a
.
♦ Remove the pre-fitted sander plate .
NOTE
The orbital sander plate can only be fitted to
the appliance in one direction . Please pay at-
tention to the arrow marks on the orbital sander
plate . These must point forwards . With the
delta sander plate the tip points forwards .
♦ Now fit the required sander plate . Ensure that
the mounting plate
B is aligned with the sander
plate . The threaded holes of the mounting plate
B must be aligned with the corresponding holes
on the respective sander plate . Align the rubber
pins
A (only on sander plates and )
with the holes in the appliance (see fig . 1) .
A
B
Figure 1
♦ Replace the four screws using the hex key
4a
.
♦ Check that the sander plate is fitted securely .
Selecting a sanding sheet
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet .
♦ Please note that you need to use appropriate
sanding sheets with different grains for working
different materials .
Fitting the sanding sheet
WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance .
NOTE
► Before fitting a new sanding sheet, remove any
dust and dirt from the sander plate
.
Attaching sanding sheets using Velcro:
♦ You can attach the sanding sheet to the sander
plate using Velcro .
♦ Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate .
Removing sanding sheets fitted using Velcro:
♦ Simply pull the sanding sheet off the sander
plate (see fig . A on the fold-out page) .
Attaching sanding sheets without using
Velcro (see fig. B on the fold-out page, not
supplied):
♦ Open the two clamping levers .
♦ Push the sanding sheet under the open clamp-
ing rail at one end and clamp it firmly in
place with the clamping lever .
♦ Follow the same procedure at the other end .