Parkside 315561, Translation Of The Original Instructions

Page: 10 / 40

GB
│
IE
│
NI
│
CY
│
7 ■ PBSD 600 A1
Removing the dust extraction adapter and
reducer for an external extraction appliance:
♦ Pull off the hose of the dust extraction appli-
ance.
♦ Remove the reducer for external dust extrac-
tion.
♦ Pull the dust extraction adapter upwards off
the connection .
Working procedures
A light grinding pressure is sufficient:
■ Apply minimal pressure when grinding. The belt
grinder's own weight is sufficient for a good
grinding result. In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth.
Removal and surface:
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt (see also the
section "Selecting speed and abrasive belt").
Grinding:
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate.
Guide the grinder in parallel and overlapping
sanding motions over the workpiece. To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain. After complet-
ing the task, lift the appliance from the work-
piece and then switch it off.
NOTE
► Always hold the appliance firmly with two
hands while working.
Use
Switching on and off
While operating the belt grinder, you can choose
between instantaneous and continuous operation.
Switching to instantaneous operation:
♦ Press the ON/OFF switch .
Switching off instantaneous operation:
♦ Release the ON/OFF switch .
Switching to continuous operation:
♦ Press the ON/OFF switch , keep it pressed in
and then press the lock button .
Switching off continuous operation:
♦ Press the ON/OFF switch and then release
it.
Emptying the dust collector
The dust collector should be emptied after every
10 minutes of operation at least.
♦ Pull the dust collector off ( see section
"Attaching/removing a dust extraction unit" )
♦ Shake the dust collector over a rubbish bin
to empty it.
♦ Fit the dust collector back onto the appli-
ance.