Parkside 315340, Operating And Safety Instructions Manual

Page: 18 / 68

13 GB/IE/NI
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, the mains circuit
breaker switched off Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up slowly
and does not reach oper-
ating speed. Voltage too low, coils damaged, capacitor burnt Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a specialist
Motor makes excessive
noise Coils damaged, motor defective Arrange for inspection of the motor by a specialist
The motor does not reach
its full power. Circuits in the network are overloaded (lamps,
other motors, etc.) Do not use any other equipment or motors on the same
circuit
Motor overheats easily. Overloading of the motor, insufficient cooling of
the motor Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Saw cut is rough or wavy Saw blade dull, tooth shape not appropriate for
the material thickness
Re-sharpen saw blade and/or use suitable saw blade
Workpiece pulls away
and/or splinters Excessive cutting pressure and/or saw blade not
suitable for use Insert suitable saw blade
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required
for use as consumables.
Wear parts*: carbon brushes, saw blade, table inserts, sawdust bags
* Not necessarily included in the scope of delivery!