PHDB 4 B2
■
10
│
GB
│
IE
│
NI
Safety devices
The safety devices are designed to protect the user and may not be de-
activated or repurposed.
Relief valve
■
If the hand spray gun is closed, the relief valve opens and the high-pres-
sure pump routes the water back to the pump suction side. This prevents
the permissible working pressure from being exceeded.
■
The relief valve is set and sealed at the factory. It may only be adjusted
by the customer service.
Safety valve
The safety valve opens if the permissible maximum allowable working
pressure is exceeded (see technical specifications); the water flows out.
The safety valve is set and sealed at the factory. It may only be adjusted
by the customer service.
Thermal valve
The thermal valve protects the high-pressure pump from impermissible
warming in circulation operation if the hand spray gun is closed.
The thermal valve opens if the maximum permissible temperature of 68°C
is exceeded and drains the hot water.
Before use
NOTE
►
Exercise caution when unpacking, transporting and storing due to
the high weight of the machine.
►
These activities should be carried out by two people.
►
Make sure that the appliance is standing on a level and flat surface
while unpacking, and during assembly, storage as well as during
operation, inspection, maintenance and when at a standstill.
Fitting the handle
♦
Insert the handle
A
on the base frame of the device. Press the two
pushbuttons on the base frame and push the handle
A
completely
until it clicks into place.
Fitting the hose holder
♦
Fit the hose holder onto the handle
A
by aligning the holes in the
two components.
♦
Fix the hose holder in place on the handle
A
with two screws
and two nuts
(on the right side, see fold-out page).
Fitting the upper spray gun holder on the handle
♦
Use two screws , two washers and two nuts
to fit the upper
spray gun holder onto the handle
A
.
Fitting the lower spray gun holder on the tubular
frame
♦
Use two screws attach the lower spray gun holder onto the
tubular frame .
Fitting the wheels
♦
Push a washer
onto the axle .
♦
Push the axle from outside through the wheel and place another
washer
on the axle .
♦
Now guide the axle with the wheel from the outside into the tubular
frame . Place another washer
onto the axle and secure it in
place with the R-clip .
♦
Repeat the process on the opposite side.
Fitting the rubber feet
♦
Attach the rubber feet with the screw , washer
and nuts
onto the tubular frame .
Use the supplied open end wrench
and allen key
for assistance.
