Parkside Performance PSSAP 2028 A1, Translation Of The Original Instructions

Page: 56 / 78

PSSAP 2028 A1
GB
│
MT
│ 49 ■
Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment that are specified in the oper-
ating instructions and are compatible with
the appliance.
Using attachments or accessory
tools other than those recommended in the
operating instructions can lead to a risk of injury.
Information on saw blades
You can use any saw blade provided it is fitted with
a suitable mount – ½" (12.7 mm) universal shaft.
Saw blades optimised for your sabre saw are avail-
able from retail stores in different lengths for
various purposes.
NOTE
► TPI = teeth per inch = the number of teeth
per 2.54 cm
Wood saw blade
Dimensions: 152 x 1 mm, 6 TPI
Ideal for: sawing construction wood, chipboard,
panels and plywood, and also plunge cuts.
Bi-Metal Saw Blade
Dimensions: 150 x 0.9 mm, 24 TPI
Best suitability: for sawing sheet metal, profiles and
pipes.
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
♦ Connect the battery pack to the high-speed
battery charger (see fig. A).
♦ Insert the power plug into the socket.
The control LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack is
ready.
ATTENTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Push the battery pack into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack to click into place
in the appliance.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to check
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery