11
www.parker.com/euro_pneumatic
10. Shut Down and Storage
• Turn the air supply to “OFF”.
• Disconnect the air motor from the air supply.
• Disconnect the air motor from the equipment it is attached to.
• Remove the silencer package (if one is installed).
• Blow clean and dry air (using a low pressure) into the air-inlet
port of the air motor.
• Drip a couple of oil-drops into the inlet port and turn the shaft
by hand to distribute the oil. Recommended oil:
see chapter 7 – “Lubricants”.
• Close all connections.
• The air motor may now be stored until needed again.
11. Technical Data
The air motors are supplied as “Components for installation” – the
installer is responsible for ensuring that the motors are installed safely
in the overall system.
Parker Pneumatic guarantees that its products are safe, and as a
supplier of pneumatic equipment we ensure that the equipment is
designed and manufactured in accordance with the applicable EU
directive.
Most of our products are classed as components as defined by various
directives, and although we guarantee that the components satisfy the
fundamental safety requirements of the directives to the extent that they
are our responsibility, they do not usually carry the CE mark.
Nevertheless, most P1V-S motors carry the CE mark because they are
ATEX certified (for use in explosive atmospheres).
The following are the currently applicable directives:
• Machinery Directive(essential health and safety requirements relating
to the design and structure of machines and safety components)
• EMC Directive
• Simple Pressure Vessels Directive
• Low Voltage Directive
• ATEX Directive (ATEX = ATmosphere EXplosive)
12. CE marking
EC-Declaration of Incorporation in accordance with the
EC Machinery Directive 2006/42/EC, Annex IIB
As supplier of the partly completed machine we declare that:
• the essential requirements of the Directive 2006/42/EC and where
applicable the other Directives and Standards listed below apply to
the specified machine.
• the relevant technical documentation is compiled in accordance with
part B of Annex VII.
• the relevant technical documentation in accordance with part B of
Annex VII will be transmitted in response to a reasonable request by
the national authorities in printed form or in electronic form (pdf).
Required documents have been filed - under Directive 2014/34/EU,
Annex VIII - with the following authority:
IBExU, Institut für Sicherheitstechnik GmbH EU reference number
IBExU15ATEXB006 X.
Supplier
Parker Hannifin Manufacturing
Germany GmbH & Co. KG
Pneumatic Division Europe
Industriestrasse 8
70794 Filderstadt Germany
13. EC-Declaration of Incorporation
Please refer to the technical catalogue PDE2554TC
