PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
13
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
Daily
1.
Grease the thrust washers at the two grease
fittings with a high quality Lithium-based
grease. Apply grease until clean grease
flows from the grease reliefs. Severe
operating conditions such as abrasive dust or
prolonged submersion in water may require
more frequent grease applications.
2.
Make sure the grease reliefs are functioning
properly. Open or replace non-functioning
grease reliefs immediately.
NOTICE
Never replace the grease relief
valves with grease fittings or
plugs.
NOTICE
Do not operate the PowerTilt if the
grease reliefs are not functioning.
3.
Inspect the PowerTilt for loose, worn or
damaged components and replace or repair
immediately.
4.
Mounting pins should be greased upon
installation and thereafter according to the
equipment manufacturer's instructions.
Monthly
Check shaft end play. When the end play exceeds
0.38 mm, the end cap must be tightened. See
page 14 and 15 for detailed instructions.
Installation and Maintenance
Maintenance
