Mounting / Repair
PLEASE NOTE: THIS IS HAUSER GERMANY MANUAL.
FOR USA NOMENCLATURE PLEASE GOTO PARKERMOTION.COM
36
5.4.6 Adjusting the reference point
Correct the machine zero point on the basis of the previously-marked carriage position. There
are several ways of doing this depending on the motor and the controller. For further details,
see the controller handbook.
5.5 Re-lubricating the steel guide
1. Disconnect the control unit.
2. Align the centre of the carriage to the position of the lubrication access hole.
Warning
Always check again that the control unit is disconnected because you will need to
reach into the guide when re-lubricating!
3. Unscrew plugs from HPLA profile.
Note
Only use the following oil: Shell Omala Oil 220, order number: 180-006026.
4. Push the lubrication
gun through the ac-
cess bore and push
onto the nipple in the
carriage.
5. Apply four to five
strokes of re-lubrica-
tion.
6. Remove manual lubri-
cation press and screw
in the plug.
5.6 Changing or attaching the motor
Danger
Danger due to electrical voltage. Work on the motor terminal box may only be carried
out by an electrical engineer.
5.6.1 Changing the motor in combination with a Stöber planetary gearbox
1. Move the carriage to a reference point (e.g. machine zero or real zero). Mark the carriage
position on the HPLA profile (felt pen).
Planeteary gearbox
Motor
shaft
Motor adapter
20
30
50
40
30
41
40
2. Switch off the actuator at the main switch and disconnect it from the electrical supply. Leave
the motor and gearbox to cool.
3. Remove the motor and resolver cable.
4. Remove plug on assembly bore (30) of adapter housing
5. Unfasten the clamping screw (41) on the clamping ring; to do this guide extension of torque
wrench through assembly bore (30)
6. Loosen the motor fastening.
Centre of
carriage
