Parker AQUA DUO - A455C, Technical Manual

Page: 63 / 81

63
with or are not proficient in the above fields of expertise.
USE CAUTION WHEN TROUBLESHOOTING. DO NOT PERFORM MAINTENANCE UNLESS:
1.
The system Feed Water Sea Cock Valve [2] is closed.
2.
The system main electrical disconnect switch is switched "OFF", LOCKED, and TAGGED
3.
The "EXPLODED PARTS VIEWS" of this manual is available.
Caution: ELECTRICAL SHOCK HAZARD. A Volt / Ohm Meter will be necessary. The
following procedures expose the technician to High Voltage and electrical shock
hazard. Only attempt this if you are a qualified electrician and only if surrounding
conditions are safe.
7.7 Weekly Quick Check
The following steps ensure that potential problems are resolved preventing major repairs:
1.
Inspect all fasteners for tightness including brackets, screws, nuts, and bolts. Pay special
attention to the High- Pressure Pump and Electric Motor since they are subject to
increased vibration.
2.
Ensure that Sea Strainer, if installed, is clean and does not restrict flow.
3.
Check the level of the High-Pressure Pump crankcase oil. The minimum oil level is the
center of the sight glass, located at the side of the High-Pressure Pump; the maximum oil
level is at the top of the sight glass window. Use only Parker High Pressure Pump oil.
DO
NOT USE MOTOR OR OTHER HYDRAULIC OIL.
4.
Clean any salt water or salt deposits from the system with a wet rag.
5.
Check for fluid leaks; either oil from the High-Pressure Pump or water from anywhere in the
system.
6.
Check all tubing and high-pressure hoses for wear and friction against abrasive
surfaces. The hoses should not contact heated or abrasive surfaces.
7.
Check Inlet Pressure to the High-Pressure Pump. If pressure is below 10 psi after 5
minutes of operation, replace Pre-Filter element.
7.8 Operator Maintenance Intervals
The frequency of required maintenance is dependent on the regularity of usage, the
condition of the intake water (the location of use), the length of time the system is exposed
to water, the total running time and, in some cases, the manner in which the system is
installed or operated. Use Table 6 in chapter 6 as a general guideline for maintenance
timeline