English
31
Replacement of cutting line and spool
Follow these steps to replace the cutting line and spool:
• Release the trigger and unplug the trimmer.
• Remove the bump knob by turning it counterclockwise.
• Remove the empty spool.
• Clean the trimmer head thoroughly. Inspect the trimmer head for any damaged or worn parts.
• Hold the spool so that its tabbed side is positioned upward.
Note: On the new spool, the ends of the lines are secured in slots on tabs. Release the line from the tabs,
unwind approximately 15cm of line and secure the lines in the tabs.
• Insert the lines on the new spool into the eyelets in the trimmer head.
• Place the spool on the drive shaft.
Note: To install the spool, you may need to rotate it slightly.
Note: If the line should tangle or break at the eyelets, remove the spool, feed the line through the
eyelets and reassemble the spool on the trimmer.
• Release the lines from the tabs by sharply pulling each line while pushing down on the spool.
• Push down on the spool to reveal the drive shaft.
• Place the bump knob on the drive shaft.
WARNING:
Make sure the trimmer head stops rotating. Contact with a rotating trimmer head could cause personal
injury.
OPERATION THE HEDGE TRIMMER
Do not work with an angle higher than 60°. The hedge trimmer work
under higher degrees, but there is the danger of being injured by
branches falling without warning.
Keep an eye at the ground while working to avoid tripping over fallen
branches.
The Hedge trimmer is equipped with a blade and it was also done
everything from an engineering point of view to keep kickback low.
Nevertheless, some kickback can not be avoided when cutting with the
upper tip of the blade. Be prepared for some kickback when using this
area of the blade or hitting another branch with this area. Always hold
the unit firmly in both hands.
Cutting Tips:
