English
27
Assemble the brush cutter.
1. Remove the 3 screws in the head of the gear head.
2. Place the flanged washer over the gear head shaft with the hollow side.
3. Center the blade (7) on the flanged washer, making sure the blade fits flat and the raised hub of the
flanged washer goes through the hole in the blade.
4. Install the cupped washer with the raised center away from the blade.
5. Place the left-hand nut onto the gear head shaft.
6. Place the allen key (10) through the slot in the flanged washer and gear head.
7. Install the blade nut by turning it counterclockwise use the nut spanner (11).
8. Tighten the blade nut securely and torque to 2N.m minimum.
Install the brush cutter shield
1. Place the two guard washers (16) on the bottom of brush cutter shield (8).
2. Align the holes in the guard cover the holes in the bracket(15), and locate four screws,
3. Tighten the screws securely and torque to 1.8N.m minimum.
Note:
1. Always ensure the shield is fitted to the tube whenever you operate this tool.
2. Store the brush cutter parts together for later use.
