PROCEDURE:
CAUTION
Risk of infection due to moisture
Moisture encourages the growth of bacteria.
• Remove all parts from the pot as soon as the disinfection
process is finished and allow them to dry.
• Place all the
individual parts
in boiling water (100 °C) for at
least 5 minutes.
NOTE! Risk of damage to plastic parts!
Plastic will melt if it
comes into contact with the hot base of the pot. Make sure
there is enough water in the pot to prevent the individual
parts from touching the pot base.
DRY:
• Shake the water out of all of the parts.
• Place all parts on a dry, clean and absorbent surface and al-
low them to dry completely.
Using a standard thermal disinfector for baby bottles (not
a microwave oven)
EQUIPMENT:
– Thermal disinfector with a runtime of at least 6 minutes.
PROCEDURE:
CAUTION
Risk of infection due to inadequate disinfection
Inadequate disinfection encourages the growth of bacteria
and thus increases the risk of infection.
• Make sure that the disinfector is clean and operating prop-
erly before every disinfection process.
• Allow the disinfection to continue until the disinfector
switches off automatically or the minimum disinfection
time stated in the instructions for use of the disinfector has
elapsed. Do not switch the device off prematurely.
– 18 –