Paragon P7, Installation & Maintenance Instructions Manual, Page: 7 / 28

7 LT6757 ( Iss 1 06/14 )
P7 Users Instructions
SECTIONTHREE Cleaning
Warning: -
Before you clean any part of
the appliance ensure that the
appliance is turned off and
cold.
CLEANING: PILOT
ASSEMBLY (With
Fireplace frame fitted)
(Before cleaning ensure that
the appliance is turned off and
cold)
In some instances you may
experience ignition problems
even when the appliance is
new. This may be due to the
aeration hole in the pilot body
being partial blocked with dust,
pet hairs, or other foreign
matter. The source of this
debris could be such things as carpet fibres, decorating or pet etc.
To gain access to the pilot please do the following.

Remove the log fuel bed shapes and bark shapes.

Lift out the air tray assembly from the location points within the shelf.
The pilot is located on the right hand side of the appliance, any debris in or around the aeration hole
should be remove using the nozzle of a vacuum cleaner. It is advisable not to blow the debris into the
hole as this may cause more of a restriction and not rectify the problem.
Note: - Take care when cleaning in this area so as not to damage the pilot assembly.
P7 Users Instructions
SECTION FOUR Fuel Bed Cleaning and Layout

Before you clean any part of the appliance ensures that the appliance is turned off and cold.

Use only the fuel bed components provided and no additional parts must added.
Important: -
Refer to the ‘Health & Safety Notice located on page 3 of this booklet
before
cleaning or replacing any refractory material.

The fuel bed components are delicate and they should be handled with great care.

The moulded shapes may be removed for cleaning. They can be brushed very gently with a soft
brush to remove dust or any deposits.

A vacuum cleaner may only be used after the loose components and moulded shapes have been
removed.
CARE SHOULD BE TAKEN TO AVOID CONTACT WITH THE REFRACTORY LINING THIS IS A
DELICATE SURFACE AND SHOULD
NOT BE WIPED OR RUBBED.
It is important that all the fuel bed moulded shapes are positioned as shown in these
instructions.