2000-A2-GB20-10
- 59 -
February 2004
Configur-
ing the
SDSL Inter-
face—
JF2100
The tasks described in this section all begin on the G2237 xDSL
Configuration menu. The tasks are described so you can proceed through
them sequentially. You should review and update each of these options as
necessary, and reset the IAD when you finish WAN configuration.
To configure the SDSL interface, Type
2
(Configure Physical Interface) on
the WAN Configuration menu to display the G2237 xDSL Configuration
menu:
Figure 4–13. G2237 xDSL Configuration Menu
Selecting CPE or CO Mode
1. Type
2
to display the Configure CPE/CO Mode menu.
Figure 4–14. Configure CPE/CO Mode Menu
Type
1
to select CPE, or type 2 to select CO mode.
2. The IAD sets the mode and displays the menu.
3. Press Escape to return to the SDSL Configuration Menu.
LAN LINK
LAN ACT
WAN LINK
VOICE
POWER
JF2104
JF2104i
JF2108
This section is only for configuring the SDSL WAN interface
on the JF2104, JF2104i and JF2108.
******************************************
G2237 xDSL Configuration
******************************************
Current Interface Type is: SDSL.
Mode: CPE, Rate Mode: NOKIA AUTO-CYCLE,
Line Rate: 88K, Debug: DISABLED
1. Select xDSL Interface Type
2. Select CPE/CO Mode
3. Enable/Disable Adaptive Rate Mode
4. Select Line Rate
D. Enable/Disable G2237 xDSL Debug Messages
*******************************************
Configure CPE/CO Mode
*******************************************
Current Mode: CPE
1. CPE
2. CO
