2000-A2-GB20-10
- 91 -
February 2004
Configuring Maintenance Protocol (page
93
)
Configuring Congestion Parameters (page
93
)
Enabling or Disabling Coppermountain CMCP (page
94
)
Selecting Fragmentation Types
To select which fragmentation to use:
1. On the Frame Relay Options menu, type
1
to display the FR
Fragmentation Configuration menu.
Figure 4–61. Frame Relay Fragmentation Configuration Menu
2. Do one of the following:
a. Type
1
to select Configure FRF.12 Fragmentation—go to FRF.12
Configuration, following.
—or—
b. Type
2
to select CopperMountain Fragmentation—go to
CopperMountain Fragmentation Configuration, on page
92
.
Setting FRF.12 Configuration
If you selected FRF.12 Fragmentation, the IAD displays the FRF.12
Configuration menu:
Figure 4–62. FRF.12 Configuration Menu
Type the option and proceed to the corresponding section.
Enabling or Disabling FRF.12
1. Type
1
to enable or disable FRF.12.
The IAD displays the status and a prompt:
FRF.12 Fragmentation is currently DISABLED
Enter E to Enable, D to Disable:
Type
E
to enable End-to-End fragmentation, or type
D
to disable it.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page
14
) when you finish Frame Relay configuration.
*****************************************
FR Fragmentation Configuration
*****************************************
1. Configure FRF.12 Fragmentation
2. Configure CopperMountain Fragmentation
*****************************************
FR FRF.12 Configuration
*****************************************
1. Enable/Disable FRF.12
2. Enable Automatic Fragment Sizing
3. Set Manual Fragment Size
