3
8776-A2-GZ40-10
August 1998
Cables You Need
The following standard cable is used with this product.
For the network connection:
Plug-ended Telco 50-pin cable for connection from the Hotwire 8600 DSLAM
LINE port or one of the Hotwire 8800 DSLAM LINES ports to the Main
Distribution Frame (MDF) or other demarcation point.
For the DTE connection:
For further information refer to Appendix C,
Connector Pin Assignments, in
the User’s Guide.
Installing DSL Cards
Use a small- to medium-size flat-blade screwdriver to install the 8776 Termination
Unit.
When installing the unit
into a . . .
Place the termination unit in . . .
Hotwire 8600 DSLAM base
chassis
Slot 2 or 3 (Slot 1 of the Hotwire 8600 DSLAM base
chassis must contain a Management Communications
Controller (MCC) card).
Hotwire 8600 DSLAM
expansion chassis
Slot 1, 2, or 3.
Hotwire 8800 DSLAM
chassis
Any one of the first 18 slots (i.e., Slot 1 through 18).
A Hotwire 8776 Termination Unit can be installed, removed, and replaced from a
the DSLAM chassis without disrupting service to the other cards in the chassis.
NOTE:
When installing the Termination Unit, you need to remove the filler plate
before proceeding.
Do not discard unused filler plates. Each slot in the chassis must contain a
circuit card or a filler plate. Store all unused filler plates in a safe place. You
may need to use the filler plates to cover open slots in the chassis at a later
time.
