Paradyne FrameSaver DSL 9783 CSU/DSU, Installation Instructions Manual, Page: 8 / 28

8
4. Connect one end of the DTE’s cable to the user data port labeled PORT. Plug the
other end of the cable into the DTE (router or FRAD). Tighten the screws on each
side of the connector.
5. Use a VT100-compatible asynchronous terminal or a PC to set up management
access to the unit. Insert the DB25 end of the EIA-232 cable into the CSU/DSU’s
COM port. Tighten the screws on each side of the connector. Insert the other end of
the cable into the terminal or PC.
The terminal or PC’s configuration must be compatible with the CSU/DSU’s. Refer
to the procedure on
page 13 of Configuration Setup . If connecting an external
modem to the COM port, refer to Connecting an External Modem on page 22.
01-16689-02
ETHERNET
P
O
R
T
COM
POWER
NET
DTE
PORT
COM
Port
01-16685-02
ETHERNET
P
O
R
T
COM
POW
ER
NET
VT100
Terminal