Paradyne FrameSaver DSL 9783 CSU/DSU, Installation Instructions Manual, Page: 17 / 28

17
Completing Setup From the NOC
Procedure
1. Access the remote CSU/DSU on the TS Management Link that was set up at the
remote site in Step 5 of Using the Easy Install Screen .
2. Ping the CSU/DSU five times within five seconds. The unit automatically provisions
the TS Access VC and accepts the destination IP address of the Ping as its
temporary IP address, which is used on the management VC interface.
3. If necessary, open a Telnet session and configure any specific configuration options
that require input or changes from default settings. Create all customer VCs,
including internal DLCIs and VPI/VCIs on the DSL interface, and cross-connect the
DLCIs to the VCCs.
Configuring SNMP Trap Managers and Traps
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu
→
Configuration
→
Management and Communication
→
SNMP Traps
2. Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address for each NMS Trap Manager to which traps will be sent.
— Specify the Initial Route Destination for each Trap Manager. The default is
AutoRoute.
— Select or disable trap categories, as needed.
3. Save the configuration.