TM
1
FrameSaver
9620
Network Access Module (NAM)
Installation Instructions
Document Number 9621-A2-GN10-10
July 1998
Before You Begin
Make sure you have:
A small flat-blade screwdriver.
A small Phillips screwdriver if transferring an ISDN BRI DBM to the replacement
NAM (for use in 1-slot housing only), or if installing the NAM in a 9000 Series
Access Carrier.
1-Slot Assembled Access Unit Installation Instructions (Document
No. 9000-A2-GN10) to install the 1-slot access unit once the NAM is installed, or
9000 Series Access Carrier Installation Instructions (Document
No. 9000-A2-GN1D) for power-up verification procedures, if using an access
carrier.
ISDN BRI Dial Backup Module (DBM) Installation Instructions (Document No.
9000-A2-GN19) to uninstall, then reinstall a DBM if one is currently installed on the
NAM being replaced.
Configuration information for the NAM being installed or replaced.
If an ISDN BRI DBM is installed on a NAM being replaced, the DBM must be
uninstalled, then reinstalled onto the replacement NAM (1-slot housings only).
Package Checklist
Verify that your package contains the following:
NAM
NAM I/O card, if installing the NAM in an access carrier
Warranty card
Training card
FrameSaver 962x Safety and Regulatory, Warranty and Service Information
(Document No. 9621-A2-GX40)
Appropriate cables
