COMSPHERE 3600 Series Data Service Units
E-2
December 1996
3610-A2-GB46-60
Messages Format
The following screen shows the message format.
F1
Command Name
Message
F2
F3
Table E-1
Command Progress Messages
Message
Condition
Command Complete
Command successfully
completed.
Command Failed
Command was not executed.
Please wait . . .
Command is taking more than
2 seconds to complete.
Table E-2
Front Panel Messages for
Enabled Async Terminal
Message
Condition
User I/F – Idle
FP Locked
Async terminal is enabled; the
front panel is locked.
User I/F – Activ
FP Locked
Async terminal is enabled and a
session is started.
Term: Stndby
Async terminal is enabled but
inactive. Front panel access has
been initiated and a valid
password entered. The async
terminal is in Standby mode.
If no key is pressed for 5 minutes,
the DSU reverts to User I/F – Idle.
Table E-3
Command Error Messages
Message
Condition
Action
Command Failed
Command could not execute and none of the
error messages below apply.
If problem cannot be corrected, call your sales or
service representative.
Conflict w/Envir
Command conflicts with test in progress,
configuration inappropriate for this
command, or configuration option settings
are not compatible.
1. Check for a test in progress.
2. If there is a test in progress, either wait for the
test to finish or abort the test.
3. If there is no test in progress, check
configuration option settings.
Inval Selection:
No Valid Choices
Invalid menu selection based upon previous
selections that caused a menu to display
with no selectable options.
Press any key to return to the top-level menu.
No Response
Invalid remote address or remote device not
powered, connected to network, or enabled.
Check remote address and status.
Not in Menu
NMS command not in supported set of
commands for NMS.
Use a valid NMS command.
