COMSPHERE 3600 Series Data Service Units
2-2
December 1996
3610-A2-GB46-60
Installation Process
•
Verifying the S1 Switch Settings
•
Powering Up the DSU
•
Connecting to the DDS Network
•
Network Verification Testing
•
DTE Connections
DSU Installation Planning
The Model 3610 DSU is designed for desktop
operation.
•
Place the DSU in the planned location.
•
Allow 1 to 2 feet of clearance for cable
connections, space for the ventilation slots on the
sides, and clearance at the rear for the cable
connections.
•
Verify the S1 switch settings as indicated below.
Verifying the S1 Switch
Settings
HANDLING PRECAUTIONS
FOR
STATIC-SENSITIVE DEVICES
This product is designed to
protect sensitive components
from damage due to electrostatic
discharge (ESD) during normal
operation. When performing
installation procedures, however,
take proper static control
precautions to prevent damage to
equipment. If you are not sure of
the proper static control
precautions, contact your nearest
sales or service representative.
The Model 3610 DSU has a switch located under the
front panel. To verify or change the S1 switch settings,
remove the front bezel:
.
Procedure
1. Place a small screwdriver or your thumbs under
the two tabs on the outside edges of the front
bezel. Firmly press upward to separate the bezel
from the tabs.
496-14701-01
Front Bezel
COMSPHERE
3610
Front Bezel
or
2. Swing the front bezel up and set aside.
3. Change the switch settings if necessary. Use a
small instrument. Do not use a pencil.
If the DSU has . . .
Then use . . .
Two switches
Figure A.
Four switches
Figure B.
4. Reinsert the front bezel’s hinge tabs into position
at the top and swing the bezel down. Snap the
bezel back into place.
