Network Configuration Worksheets
A-2
8000-A2-GB21-20
November 1997
Management Domain Configuration Worksheets
For the management domain, configure the MCC card, DSL cards, and HotWire
5446 RTUs as follows:
Perform this task . . .
On this screen . . .
To access the screen . . .
1.
Assign an IP address to
the MCC card.
(See page A-3.)
Who Am I
Power on the HotWire
DSLAM system.
The system displays the Who
Am I screen.
2.
Clear NVRAM
if the Who
Am I screen does not
appear in Task 1.
(See page A-5.)
(HotWire – MCC)
NVRAM Clear
From the HotWire – MCC
menu, select:
Configuration
→
Card
Status
→
NVRAM Clear
3.
Assign an IP address to
the backplane
(s1b) on
the MCC card.
(See page A-6.)
(HotWire – MCC)
IP Network
From the HotWire – MCC
menu, select:
Configuration
→
Interfaces
→
IP Network
4.
Assign IP addresses to
the DSL cards
.
(See page A-7.)
(HotWire – MCC)
Configure DSL IP Addr
From the HotWire – MCC
menu, select:
Configuration
→
DSL
Cards
→
Set IP Address
5.
Create a default route
to
the upstream router in
the management
domain.
(See page A-9.)
(HotWire – MCC)
Static Routes
From the HotWire – MCC
menu, select:
Configuration
→
IP
Router
→
Static Routes
6.
Reset the MCC card.
(See page A-11.)
(HotWire – MCC)
Card Reset
From the HotWire – MCC
menu, select:
Configuration
→
Card
Status
→
Card Reset
7. (When Using an 8546
DSL Card)
Assign an IP
address within the
management
subnetwork for each
HotWire 5446 RTU
connected to an 8546
DSL card.
(See page A-12.)
(HotWire – DSL)
IP Network
From the HotWire – DSL
menu, select:
Configuration
→
Interfaces
→
IP Network
8.
Configure a static route
to an NMS
(on each DSL
card).
(See page A-14.)
(HotWire – DSL)
Static Routes
From the HotWire – DSL
menu, select:
Configuration
→
IP
Router
→
Static Routes
Use the worksheets in the following sections to record your network configuration
settings. Photocopy the worksheets as needed.
