required data is entered, the keypad will emit a
confirmation beep and the Parakey will
automatically save and exit the section. If you make
a mistake, pressing [
CLEAR
] when entering data will
erase the current entry. Return to step 3 or press
[
CLEAR
] to exit Programming Mode.
• Sections [09] to [16]
RF Programming - Press the [
ENTER
] key and press
button 1 twice on the remote control to assign
remote control to corresponding user. The keypad
will emit a confirmation beep and the Parakey will
save and exit the section. Return to step 3 or press
[
CLEAR
] to exit Programming Mode.
• Sections [25] - [30]
Decimal Select - Each section represents one
feature and each key from [0] to [8] represents a
specific setting. Unlike feature select programming,
only one key can be selected. The selected key will
remain illuminated. Press the key representing the
desired setting and press [
ENTER
].
• Sections [17] - [24] & [31] - [35]
Feature Select - After entering the section, each key
from [1] to [8] represents a feature or option. The on/off
status of these keys determines the feature's setting.
Turn the keys on/off by pressing the appropriate key
until the desired options are set and press the [
ENTER
]
key. The keypad will emit a confirmation beep and the
Parakey will save and exit the section. Return to step
3 or press [
CLEAR
] to exit Programming Mode.
PROGRAMMING THE SYSTEM
Section [35] - Feature Select Programming: [1]
The Parakey can be set to accept 6-digit or 4-digit User
and Installer Access Codes.
Key [1] OFF = 4-digit access codes.
Key [1] ON = 6-digit access codes (default).
This option must be set to the same access code
length as set in the control panel at address 088,
key [9].
Section [00] - Access Code Programming
The Installer Code provides you with access to program
all the functions & features of the Parakey System. The
Installer Code can be 4 or 6 digits in length (see section
4.1) with each digit being any value from 0 to 9.
The Parakey system supports up to eight users, each with a
different remote control. As demonstrated in figure 5, the
three parameters listed below are specific to each user and
each user must be defined with all three of these parameters.
• User Access Code
• Remote Control Assignment
• User Remote Control Options
4.3 User Parameters
4.2 Installer Code (Default: 757575)
4.1 Access Code Length
12
13