14
User Guide
Power Save Mode
(MG32LRF only)
If there is power loss on the wireless keypad, the module’s display will shut off and go into power save mode after one minute. Press the
[I
NFO
]
key to activate the display.
Trouble Display
Your alarm system continuously monitors several trouble conditions that can be reported directly to your monitoring station. When a
trouble condition occurs, the [
TBL
] key will illuminate. We strongly suggest that you inform your monitoring station of the trouble and
allow them to service your system.
The keypad can be programmed to emit a
BEEP
every 5 seconds whenever a new trouble condition has occurred. Press the
[
TBL
]
key to stop the
“Trouble Beep”.
Trouble List
[1] Wireless Zone Low Battery
: The battery voltage in one or more wireless zones is getting low.
[2] Power Trouble
: Five types of power trouble -
[1]
The control panel is experiencing low/no battery.
[2]
There is an AC failure on the
control panel.
[3]
There is an auxiliary overload on the control panel.
[4]
A wireless keypad is experiencing AC failure.
[5]
A wireless
keypad is experiencing battery failure.
[3] Bell Trouble
: There is a bell disconnect/overload on the control panel.
[4] Communication Trouble
: Your alarm system, if monitored, could not communicate with the monitoring station.
[5] Tamper/Zone Wiring Failure
: A wiring problem is occurring on one or more zones.
[6] Module Tamper Trouble
: A module’s anti-tamper switch has been triggered.
[7] Fire Loop Trouble
: Indicates a wiring trouble on a fire zone.
[8] Timer Loss:
Your alarm system’s clock must be reprogrammed.
This is the only trouble that we recommend that you correct.
[9] Wireless Zone Supervision Loss
: One or more wireless zones are no longer communicating with the control panel.
[10] Module Supervision Loss
: One or more modules are no longer communicating with the control panel.
[16] Keypad Fault
(MG32LED/MG32LRF only): One or more keypads are no longer communicating with the control panel.
[
SLEEP
]
Keypad Fault
(MG10LEDV/H only): One or more keypads are no longer communicating with the control panel.
How do I access the Trouble Display?
1
Press the
[
TBL
]
key. The
[
TBL
]
key will flash and number(s) corresponding to the trouble(s) will illuminate (except
MG32LCD)
2
Read the corresponding explanation of the trouble from the
Trouble List
below. If no repair instructions are given, call your
monitoring station for repairs.
3 Press the
[
CLEAR
]
key to exit.
How do I reprogram the clock?
1 Press
[8]
for Timer Loss.
2
Enter the hour and minutes. If the hour is between 01 and 12, you will need to select
[1]
for 24Hr format,
[2]
for AM, and
[3]
for PM setting. If the hour is above 12, the system will automatically select the 24Hr format.
3 Enter the year (4 digits).
4 Enter the month (2 digits).
5 Enter the day (2 digits). You have now set the Time & Date. Press
[
CLEAR
]
to exit.
