HD77 Installation Guide
15
3. In the router’s configuration page, check the DHCP settings:
Step 1.
If DHCP is enabled, verify that the IP address range is large enough to accommodate all of your
cameras. Four cameras will require 4 IP addresses.
Figure 10 – DHCP Enable
Step 2.
Record one address at the upper end of the DHCP range for each HD77 in your system. You will
need two ports for each IP address one port for (port 80) for HTTP and one port for (port 443)
for HTTPS.
Step 3.
DHCP Settings (screenshot may differ depending on type of router used).
Figure 11 – Port Forwarding
Figure 12 – Fill in the Port Forwarding Information
