Paradox Digiplex V2.14, Programming Manual

Page: 4 / 48

2
PROGRAMMING GUIDE
Getting Started
WHAT DO I DO FIRST?
STEP 1: Collect all the serial number labels from the Digiplex Modules and affix them in the spaces provided in the Serial
Number List on page 4.
STEP 2: In sections [001] to [148] program the required zones.
STEP 3: Program the remaining sections.
HOW DO I PROGRAM THE CONTROL PANEL?
With the WinLoad Upload/Download Software, the Digiplex control panels can be programmed remotely through a modem or
on-site at 19,200 Baud with a 306 Adapter . The Digiplex control panels can also be programmed by using any keypad
connected to the control panel. To program the Digiplex control panel using a keypad, you must enter Programming Mode as
shown below. You can also copy the programmed contents of one Digiplex control panel into the Paradox Memory Key . Then
copy the contents of the Paradox Memory Key into as many Digiplex control panels as you need. Each control panel is
programmed in less than 5 seconds. For more information refer to “Paradox Memory Key” on page 38.
SINGLE DIGIT ENTRY METHOD
Some sections will require that you to enter Decimal values from 000 to 255 . Sections requiring Decimal entries will be
clearly indicated in this Programming Guide . Other sections will require that you enter Hexadecimal values from 0 to F .
Some sections may require one hexa-digit and others may require up to 32 hexa-digits. Some sections may not allow the
entry of all hexadecimal values. These sections will clearly indicate which values can be entered. When entering the final digit
in a section, the control panel will automatically save and advance to the next section.
MULTIPLE FEATURE SELECT PROGRAMMING
Some sections will require that you enable or disable from 1 to 8 options in one section, where each number from 1 to 8
Default Installer Code: 000000 (see section [800] on page 37)
Default System Master Code: 123456 (see section [950] on page 37)
To Enter Programming Mode:
STEP 1: Press and hold the [0] key
STEP 2: Enter your [
INSTALLER CODE
]
STEP 3: Enter 3-digit [
SECTION
]
Everything in the control panel is programmed into sections [001] to [990].
Enter section [000] to view the keypad’s serial number.
STEP 4: Enter required [
DATA
]
The type of data required will be detailed in this "Programming Guide" and/or
explained in the appropriate section of the installation manual.
Key Value or Action Key Value or Action
[0] to [9] 0 to 9 (Hexa & Decimal) [
BYP
] E (Hexa Only)
[
STAY
] A (Hexa Only) [
MEM
] F (Hexa Only)
[
FORCE
] B (Hexa Only) [
CLEAR
] Exit section without saving (Hexa & Decimal)
[
ARM
] C (Hexa Only) [
ENTER
] Save current data and advance to next section (Hexa Only)
[
DISARM
] D (Hexa Only)