ENGLISH
8
OPERATING AND MAINTENANCE MANUAL
L
Use only genuine spare parts and
authorized service organizations.
L
Before every race it is strongly
recommended to clean the motor by
introducing diesel oil (~10cc) through
the air inlet, while keeping the trigger
pressed; then running the wheel gun
clockwise and anticlockwise (please pay
attention to the exhaust coming out from
the top of the wheel gun during this
operation -
view figure Fig.2-B
). After
the inside washing, repeat the previous
operation with special oil for Paoli air
impact wrench motors (~5cc) or very
fluid oil for air tools
(
view figure Fig.2-I
).
These operations must be performed in a
suitably equipped working environment,
complete with extraction equipment
for nebulised particles. Use personal
protective equipment.
L
If the wheel gun is left unused for
long periods we recommend putting
some oil (special oil for Paoli air impact
wrench motors) into the air inlet (
view
figure Fig.2-I
) and letting it run for a few
seconds before putting it away. In this
way the internal components will remain
lubricated.
Before any maintenance, always make
sure that the air supply of the wheel gun
is depressurized (no air pressure), and
only after unplugging the wheel gun and
performing maintenance.
L
Use only recommended lubricants.
L
Every 20-30 cycles it is recommended to
fill (special oil for Paoli air impact wrench
motors or very fluid oil for air tools) the
oil tank, by loosening (use a 10 mm Allen
key) the oil plug in the bottom side of
the wheel gun; then tighten again this
oil plug
(view figure Fig.2-A
). The oil tank
capacity is ~ 7 cc. These operations alow
to keep the appliance efficient and to
extend its service life.
L
Ship the wheel gun back to the PAOLI
facilities at least once per year for the
complete overhauling.
L
Do not carry out maintenance with
improper tools, make use of the attached
exploded drawing with the list of spare
parts.
L
Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions,
if any, and the corrective action.
MAINTENANCE INSTRUCTIONS
Separate the components on the basis of the nature of the materials of which they are made. The
components must be disposed of according to the laws in force.
SCRAPPING
Summary of Contents for DP 6000
Page 55: ...ATTACHMENTS TECHNICAL CHARTS 55 ...
Page 56: ...ATTACHMENTS TECHNICAL CHARTS 56 ...
Page 63: ......