Paoli DP 36 SF EVO, Operating And Maintenance Manual

Page: 6 / 56

ENGLISH
6
OPERATING AND MAINTENANCE MANUAL
L
Before every race it is strongly recommended
to clean the motor by introducing diesel
oil (~10cc) through the air inlet, while
keeping the trigger pressed; then running
the wheel gun clockwise and anticlockwise
(please pay attention to the exhaust coming
out from the top of the wheel gun during
this operation - view figure Fig.2-B ). After
the inside washing, repeat the previous
operation with special oil for Paoli air
impact wrench motors (~5cc) or very fluid
oil for air tools. These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
L
If the wheel gun is left unused for long
periods we recommend putting some
oil (special oil for Paoli air impact wrench
motors) into the air inlet ( view figure Fig.2-A )
and letting it run for a few seconds before
putting it away. In this way the internal
components will remain lubricated.
Before any maintenance, always make sure that
the air supply of the wheel gun is depressurized
(no air pressure), and only after unplugging the
wheel gun and performing maintenance.
L
Use only recommended lubricants.
L
At regular intervals supply the wheel gun with
the addition of lubricant (special oil for Paoli
air impact wrench motors or very fluid oil
for air tools), in order to keep the appliance
efficient and to extend its service life. Place
a few drops of oil in the air inlet of the wheel
gun ( view figure Fig.2-A ).
L
Use only genuine spare parts and authorized
service organizations.
L
Ship the wheel gun back to the PAOLI
facilities at least once per year for the
complete overhauling.
L
Do not carry out maintenance with improper
tools, make use of the attached exploded
drawing with the list of spare parts.
L
Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions, if
any, and the corrective action.
MAINTENANCE INSTRUCTIONS
Separate the components on the basis of the nature of the materials of which they are made. The
components must be disposed of according to the laws in force.
SCRAPPING
INSTALLATION OF ACCESSORIES
Before changing an accessory, always make
sure that the air supply line is depressurized
(no air pressure), and only after disconnecting
the wheel gun and replace it.
Use only accessories suitable for the job (view
our catalogue for accessories).
Use only impact sockets with a hole for the
locking pin.
Do not use chrome sockets or for manual use.
Do not use square drive adapters (reductions
or multiplies).
To install the wheel nut socket, proceed as
follows:
L
“Square drive with hole and with retainer
ring”(not valid for US Version): Insert the
socket “A” in the square drive of the wheel
gun with an axial pressure, and connect using
the pin “S” and the ring “R” ( view figure
Fig.2-G ). Always check that the locking pin
of the socket is present and secured firmly.
L
“Square drive with securing pin” (valid only
for US Version): Stick the socket so far onto
the square drive of the wheel gun until
the securing pin “A” snaps in ( view figure
Fig.2-H ). To release, use pin “B” to press
the securing pin “A” and then pull off the
socket ( view figure Fig.2-I ).