ENGLISH
OPERATING AND MAINTENANCE MANUAL
13
Translations of the original operating instructions
-
The original language of these instructions is Italian.
Separate the components on the basis of the nature of the materials of which they are made.
SCRAPPING
L
“Square drive without hole and with
retainer ring”: Insert the accessory “A” in
the square drive of the tool, with an axial
pressure (
view figure Fig.4
).
When changing accessory, always disconnect
the pressure lines.
Use only accessories suitable for the job.
ACCESSORIES ASSEMBLY
L
Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions, if
any, and the corrective action.
L
If the tool is left unused for long periods
we recommend putting some oil into the
air inlet and letting it run for a few seconds
before putting it away. In this way the internal
components will remain lubricated.
L
Spare parts can be purchased in the “service kit”
package. Details of the service kit components
are available on our general catalogue.
L
Every three weeks run the wheel gun
clockwise and anticlockwise putting
special oil for Paoli air impact wrench
motors (~5cc) or very fluid oil for air tools
into the air inlet. These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
L
Drain condensation at the air filter and the
compressor daily (
view figure Fig.1
).
MAINTENANCE
L
If you have used a lower torque, screw
on again using an appliance with the
right torque, in order to avoid the risks of
insecure tightening.
L
If you avoid operating at a higher pressure
than the one required you will save energy,
make less noise, and have less wear on the
appliance.
L
Always use an impact wrench with the
tightening torque corresponding to the one
required by the application.
L
If by mistake you have used a higher torque
than the one required:
⚪
in the case of screwing, replace the bolt
and reform the tread you screwed it onto,
because of it yielding;
⚪
in the case of unscrewing, replace the
bolt anyhow and check the tread you
screwed it onto.
OPERATING INSTRUCTIONS
Summary of Contents for DP 1800 PLUS
Page 46: ...ALLEGATI SCHEDE TECNICHE 46...
Page 51: ......