10
ar
t.nr
.bruk-S3-eng, Rev
. 2016-02
Panthera
AB reserves the right to make technical changes if required
SETTINGS
4) The angle of the backrest
(Fig. 10)
1) Deactivate the backrest locking function on both sides by pulling the wire (1).
2) Fold the backrest forwards.
3) Loosen the lock screws (2) a few rotations using a 4 mm Allen key. Repeat this process
on the other side.
4) Turn the backrest lock casings (3) clockwise so that the lock faucet does not fix the
backrest in place. Use the 17 mm cap key. Repeat this process on the other side.
5) Release the lock nuts (4) on both sides using the 13 mm cap key.
6) Adjust the angle of the backrest using the adjustment screws (5) on both sides. Using
the 4 mm Allen key, unscrew the adjustment screws to tilt the backrest forwards. Tighten-
ing the adjustment screws will allow the backrest to tilt backwards.
It is important to adjust both sides equally to avoid the backrest tubing becoming crooked.
Test this by placing the backrest in the upright position and checking that both adjustment
screws are touching the frame.
7) Experiment with suitable backrest angles before tightening the lock nuts (4) on both
sides.
8) Place the backrest into the upright position.
9) Turn the backrest lock casings (3) so that the lock faucets spring out into their tracks.
Use the 19 mm cap key.
10) Tighten the lock screws (2) on both sides using a 4 mm Allen key.
Fig. 11
Fig. 12
Fig. 13
Fig. 8
Fig. 9
Fig. 10
