PES197 and PES197/E: ENGLISH
PES197 & PES197/E: PA25609A01_01
Page:
14
of
17
7-2009
The table below can be consulted as soon as the error code has been identified. Having corrected the error
condition, press
PAUSE/START
or
FEED
in order to restore the working state of the Embosser.
PROBLEM SOLVING
ERROR CAUSE
SOLUTION
E-00
Machine expecting the reset command
Press
START
E-01
The loader is empty
Fill the loader
E-02
The clamp has not picked up the plate
Check that the plate is error free
E-03
Embossing motor blocked
Call Technical Support
E-04
Drum blocked
Control the punches and if the problem
persists, call Technical Support
E-05
Problem on the clamp’s trolley
Clean and oil the trolley guide and
control that it moves freely.
E-06
Problem on Clamp
The clamp has hit a fixed part of the
machine. Control the mask coordinates.
E-10
The front cover has been opened.
Close the cover and push
START
E-27
Incorrect password
Insert the correct setup password
E-28
Lost Data on Main Board
Call Technical Support
E-29
Lost Data on Drum
Ref. Software Manual
E-30
Lost Data on Drum
Ref. Software Manual
E-38
Lost Configuration
Call Technical Support
E-39
Machine without setup configuration
Configure the machine setup
E-48
Printer Off-Line
Connect the Printer
E-50
Drum motor blocked
Check the punches and retry. If the fault
persists, call Technical Support
E-53
“Single Punch” setup not configured
Re-send the parameters required
