3
Installation Guide
AT-HDR-EX-70-2PS
1. Connect a UHD/HD source to the
HDMI IN
port on the AT-HDR-EX-70-2PS-TX.
2. Connect a UHD/HD display to the
HDMI OUT
port on the AT-HDR-EX-70-2PS-RX.
3. Connect an Ethernet cable, from the
HDBaseT OUT
port on the AT-HDR-EX-70-2PS-TX,
to the
HDBaseT IN
port on the AT-HDR-EX-70-2PS-RX.
4. Connect each of the included 5 V DC power supplies to the
DC 5V
locking power
receptacles on both the AT-HDR-EX-70-2PS-TX and AT-HDR-EX-70-2PS-RX.
5. Connect each of the power supplies to an available AC outlet.
Installation
IMPORTANT:
The DIP switch, on the bottom of both the transmitter and receiver,
must be set to
HDBaseT
mode for normal operation. If this is not the case, then
disconnect power from the unit, set the DIP switch to
HDBaseT
mode, and then
reconnect the power.
LED Indicators
The
POWER
and
LINK
LED indicator on the transmitter and receiver unit provides basic
information on the current status of the AT-HDR-EX-70-2PS. The information in the table below
applies to both the transmitter and receiver unit.
POWER
Description
Solid green
Unit is powered.
Off
Unit is not powered.
•
Verify that the locking connector is securely fastened to the
power receptacle.
•
Make sure that the power supply is connected to an active
AC outlet.
IMPORTANT
:
Do not over-tighten or apply high-torque devices to the locking
connector. Doing so may damage the power receptacle and/or locking connector.
LINK
Description
Solid yellow
The link integrity between the transmitter and the receiver is
good.
Blinking yellow
Poor signal integrity between the transmitter and the receiver.
•
Make sure that the Ethernet connection between the
HD-
BaseT IN
port on the transmitter and the
HDBaseT OUT
port on the receiver is secure.
•
The Ethernet cable may be compromised. Try using a
different Ethernet cable. Make sure that the cable is solid
core. Stranded or patch cables are not recommended.
Off
The link integrity between the transmitter and the receiver is
compromised.
•
Check the Ethernet cable between the HDBaseT IN port on
the transmitter and the HDBaseT OUT port on the receiver.
