Panduit Atlona AT-JUNO-451-HDBT, Manual

Page: 14 / 49

AT-JUNO-451-HDBT 14
Installation
IP Configuration
The AT-JUNO-451-HDBT is shipped with DHCP enabled. Once connected to a network, the DHCP server (if
available), will automatically assign an IP address to the unit. Use an IP scanner, along with the MAC address on
the back of the unit, to identify both the unit and its IP address on the network. If a static IP address is desired, the
unit can be switched to static IP mode. Use one of the following procedures to switch between DHCP and static IP
mode. The default static IP address of the AT-JUNO-451-HDBT is 192.168.1.254 .
If the AT-JUNO-451-HDBT is unable to detect a DHCP server within 15 seconds, then the unit will set all IP settings
to zero.
1. Make sure the AT-JUNO-451-HDBT is powered.
2. Connect an Ethernet cable between the LAN port of the AT-JUNO-451-HDBT and the Local Area Network (LAN).
3. Press and hold the INPUT button on the front panel for approximately 20 seconds. Release the INPUT button
once the POWER button begins to flash blue and red. The number of flashes will indicate the currently selected
IP mode.
POWER button flashes Description
Two Static IP mode
Four DHCP mode
POWER button
Setting the IP Mode
HDMI OUT LAN OPTICAL RS-232
RX TX S
IR IN DC 5V
AT-JUNO-451-HDBT
INPUT
1 2 3 4
POWER INPUT FW
1 2 3 4
INPUT
AT-JUNO-451-HDBT
J
UNO
X
TM
Use the
IPStatic
and
IPDHCP
commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to
API documentation for more information. All commands and their arguments are case-sensitive.
• Setting static IP mode
1. Connect to the AT-JUNO-451-HDBT using RS-232 or Telnet.
2. At the command line, execute the IPDHCP command using the off argument, as shown.
IPDHCP off
Setting the IP Address Using Commands