12. Maintenance
12.1. General
Maintenance and overhaul is to be carried out by qualified personnel only
Warranty is based on parts and spares delivered by Pandrol.
Check tools DAILY for proper operation, leaks, or damage.
Inspect hoses DAILY. Replace cut, burned, or otherwise damaged hoses.
Keep quick disconnect couplers clean and lubricated.
Use hydraulic fluids that comply with HTMA Specification 5.7, The hydraulic fluid should have a viscosity between
100 and 400 SSU (20-82 centistokes) at the maximum and minimum expected operating temperatures. Petroleum
based hydraulic fluids with anti-wear properties and a viscosity index of over 140 work for a wide range of
operating conditions.
Have tool inspected, at least annually, by Pandrol or a Pandrol qualified service representative to determine if tool
is in need of safety changes or worn part replacement.
Contact Pandrol on a periodic basis, at least annually, for service Bulletins, safety notices, or other important
information pertaining to this tool.
Other fluids that meet or exceed this specification can be used.
* See cold weather operation hydraulic oil note.
The following oils meet HTMA Specification 5.7
WARNING!
•
All adjustments work, overhaul and service must take place with the
machine turned off. Failure to do so could lead to fatal injury.
•
It is of great importance that qualified personnel accomplish all service and
overhaul
18 av 34
OPERATION AND MAINTENANCE MANUAL I ENG_OMM_ELECTRIC_POWER_UNIT_P01 I 30th November 2021
@Pandrol 2021
