33
32
U S E R MA N UA L
PA N D O R A S MA R T V3
Remote engine start
If the system is prepared for remote start, use one of the methods described below to start the
engine, the system will confirm the command with
3х
light signalization.
Original key
The system reads digital information from a car, this allows you to start and stop the engine by an
original key.
• To start the engine, press the «LOCK» button 3 times within 5 seconds (the key must be in the radio
coverage zone.
• To stop the engine, press the «LOCK» button 3 times within 5 seconds (the key must be in the radio
coverage zone).
!
r
emoTe
engine
sTarT
by
an
original
key
doesn
’
T
required
any
addiTional
seTTings
. c
heck
if
The
funcTion
available
for
your
car
in
loader
.
pandorainfo
.
com
.
!
T
he
funcTion
becomes
available
only
30
seconds
afTer
arming
Phone
To start the engine, call the system number, wait for the answer. Dial the
command. If you
repeat the
command when the engine is running, it will prolong the operation period by 10
minutes (this procedure can be repeated multiple times).
To stop the engine, call the system number, wait for the answer. Dial the
command.
Online service
• To start the engine, login to the PANDORA-ON.COM (when the system is online there is an Internet
connection), press the START ENGINE button on the control panel. In a few seconds the engine will
be started, it will be confirmed with the spinning
icon.
armed
engine started
sop engine
start engine
START
ENGINE
START
ENGINE
STOP
ENGINE
STOP
ENGINE
prolong engine
operation (10 min)
3
2
1
*
3
2
1
*
1
2
3
*
3x
• To stop the engine, press the STOP ENGINE button on the control panel. In a few seconds the engine
will be stopped and the spinning
icon will be faded.
Mobile application Pandora Connect
• To start the engine, open the mobile application. When the system is online (there is an Internet or
Bluetooth connection) press and hold the START ENGINE button on the control panel until the scale
is fully loaded. In a few seconds the engine will be started, it will be confirmed with the spinning
icon.
• In a few seconds the engine will be started, it will be confirmed with the spinning
icon.
«Hold On» mode
This feature allows to leave the car with the engine running for a certain period (15 minutes by
default) without keys in the ignition switch. It doesn’t depend from the state (armed/disarmed) of the
security system, but «Hold On» mode will not be supported without remote start function.
To activate a «Hold On»:
1. Start the engine with the key;
2. Move the shifter to the «Park» position, for cars with automatic transmission, or engage the
parking brake for the vehicles with the manual transmission;
3. Press and hold the button at the tag for one second, until first blink of tag’s LED. Alarm/remote
starter system will activate «Hold On» mode and will hold main vehicle ignition;
4. Switch the ignition off and remove the key from ignition lock cylinder;
5. Close the doors and arm the vehicle from tag/app if necessary. Engine will run for pre-programmed
time, then it will shutdown by the end of «Hold On» function.
Service mode
It is recommended to put the system into the service mode before handing it to a car service or valet
parking. When this mode is switched on, security system stops interfering with built-in electronics and
disables all functions to ease maintenance.
To switch on this mode, disarm the system, turn on the ignition, an authorization device (a
radio tag, a Bluetooth remote control, a mobile phone) must be in the coverage zone, enter the
«Immobilizer PIN-code» (if the «Code immobilizer» function is used) and use one of the method
described below: