39
38
USER MANUAL
PANDORA DXL 1940L CAR SERVICE-SECURITY SYSTEM
tion. Select the found system, the system and the mobile device will be automatically paired. The system
will confirm the pairing with a sound signal of a siren and red light of LED indicator.
Unpairing mobile device:
LED indicator will light red after entering the level. Press
VALET
button and hold it for more than 4
seconds, release the button. The system will confirm deleting with the series of sound signals of a siren
and the system will return to mobile device registration mode (LED indicator will light green).
Saving changes:
To finish the registration of a mobile device,
VALET
button should be pressed once, the series of red
and green flashes of the status LED indicator will confirm the saving, switch on the ignition to automati-
cally save the settings and exit the programming mode.
WARNING! IF THERE IS NO AUTOMATIC PAIRING, ENABLE ‘PIN REQUEST FOR PHONE
PAIRING’ ITEM IN THE ‘RADIO TAG AND MOBILE DEVICE FUNCTIONS’ SETTINGS
AND MAKE PAIRING PROCEDURE AGAIN. THE MOBILE DEVICE WILL REQUEST
PIN-CODE (0-0-1-1-1-1)
Level 19, 20, 21, 22, 25, 26 – Updating firmware of additional Bluetooth devices
Download the firmware from www.pandorainfo.com and install Pandora BT application on your
mobile device.
To update firmware of additional devices, enter the programming mode and press VALET button the
number of times equals to the desired level number (see the Programming levels table). Find your sys-
tem in the mobile application, go to detected devices and upload the previously downloaded firmware
to the system.
Level 23, 24 – Recording door sensors №1, №2 (DMS-100 BT)
ЗDoor sensors recording is performed one by one starting from the 23 level: A door sensor №1 is re-
corded on the 23 level; a door sensor №2 is recorded on the 24 level. A door sensor can be overwritten
only on the level of its initial registration. To record door sensors №1, №2, enter programming mode and
press
VALET
button 23 times for the door sensor №1 or 24 times for the door sensor №2. LED indicator
will light green and the system will enter the recording of a door sensor mode. Insert the battery into
the sensor. The system will confirm recording with a short sound signal.
Saving changes:
To finish the recording of the Bluetooth radio relay, press
VALET
button once, the series of red and green
flashes of the status LED indicator will confirm the saving, switch on the ignition to save the settings and
exit the programming mode.
Additional device
Blocking radio relay BTR-101
Blocking BTR-101 radio relay is optionally available for Bluetooth systems. Blocking radio relay with
built-in accelerometer should be placed in the engine compartment. Herewith zone of built-in aerial
2,4 GHz should not be shielded. Provide a rigid fastening to the car body or to the fixed wirings. It is
forbidden to hide the module in wiring. To save energy, radio relay power is connected to the ignition.
Radio relay is normally closed and has a full set of contacts. Blocking is carried out on unauthorized
movement.
2
5
1
4
3
NO
NC
COM
programming
6
Antenna 2,4 GHz
+12V
WARNING! DO NOT PLACE RADIO RELAYS DIRECTLY ON THE ENGINE!