27
26
User manual
Pandora DXL-1820L/1830L service-security system
entering of the first digit with red LED indicator flash.
WARNING!
IF YOU ARE AN INSTALLER, DO NOT ERASE PROTECTIVE LAYER OF THE OWNER’S
PLASTIC CARD! IN CASE A CUSTOMER COMPLAINS ON ERASED PROTECTIVE LAYER
OF THE CARD WITH THE INDIVIDUAL PIN-CODE, RE-INSTALLATION OF THE SYSTEM
IS CARRIED OUT AT THE EXPENSE OF THE INSTALLER.
5. Similarly input the second, third and fourth digit. Every input will be confirmed with red LED
flash.
6. The system will confirm correct PIN-code with red LED flashes and proceed to the programming
mode. If the input was incorrect, it will be indicated with long red flash and the system will proceed to
previous mode. New input can be attempted after 5 seconds.
Changing core settings via computer
The system allows programming all settings and updating software of the base unit via the
interface micro-USB cable or via radio channel using a computer. It does not matter, whether base
unit is installed into a vehicle or not. Software reads the current setting and allows changing them.
If base unit has not yet been installed in the vehicle, it should be powered via micro-USB cable while
programming. To program using a computer connected via cable, you need a standard micro-USB
cable, a computer with Windows and a special piece of software – Pandora AlarmStudio.
In preparation to the programming following stages should be followed:
• connect micro-USB cable to any free USB socket of the computer;
• start Pandora AlarmStudio (can be downloaded from the web-site);
• enter the programming settings mode by entering the service PIN-code on the base unit using
VALET button. Factory preset PIN-code is
1-1-1-1
.
If the software configuration is carried out via the radio interface of 2,4 GHz, special USB programmer
RMP-03 should be used.
Configuring system settings via the wireless interface 2,4 GHz
To change the configuration of the system using a wireless interface 2,4 GHz, enter programming
level 10. The system will await a wireless connection from the computer for 2 minutes.
Entering the programming menu using VALET button
After entering PIN-code, input the number of the required level using VALET button (press button
the number of times equal to the level number; pauses between presses should not exceed 1 second).
The system will confirm the number with red flashes of LED indicator and will proceed to the desired
level. If the number is incorrect, the system will produce the series of red and green flashes and then
will await for a new level input. To exit programming mode and save the settings, switch off the
ignition.
Level 1
Recording remotes and radio tags into the system’s memory
Level 2
Changing the factory preset service PIN-code
Level 3
Recording the idle speed to the system’s memory
Level 4
Resetting to factory settings
Level 5
Programming of engine compartment module
Level 6, 7
Programming of radio relay 1 and 2
Level 8
Recording GPS/GLONASS receiver
Level 9
Reserved
Level 10
Configuring system settings via the wireless interface 2,4 GHz
Level 11
Programming validator code of immobilizer (Pin to Drive)
Level 12
Setting and updating GPS/GLONASS receiver
Level 13, 14
Reserved
Level 15
Emergency disabling of immobilizer
Level 16
Reserved
Level 17
Setting up keyless bypass of built-in immobilizer
Level 18
Reserved